Driver version 3.1 of August 7th, 2017
See also
Source of supply / manufacturer
The DASYLab driver supports the use of the universal data acquisition system MGCPlus by Hottinger Baldwin Messtechnik
Supported:
Pro MGCPlus, only the first 16 channels of each device can be addressed under DASYLab.
The driver uses a software-based protection.
The registration binds the driver to the DASYLab used. Each DASYLab PC workstation requires a separate license. Discounts for multiple licenses are available.
Within DASYLab the check of the registration is carried out at each start of a circuit diagram in which one or more MGCPlus are used. If the driver is not registered, the current circuit diagram stops with a corresponding error message.
You may place a module on the schematic via Module - Ein- /Ausgänge - MGCPlus - Analog-Eingänge
Info about the driver may be found at Help - MGCPlus-Treiber
A dialog appears:
Nehring PC-Messtechnik
Hauptstr. 18
D-56281 Dörth
Telefon: (+49) (0) 6747 6967
Telefax: (+49) (0) 6747 8177
Internet: http://www.a-nehring.de
E-Mail: Info@a-nehring.de